# Alder Well — complete Csound settings

## Signal flow

Sine modulator → carrier frequency → tracked lowpass → shared soft saturation → predelayed stereo room → gain trim and DC removal.

This is an interpretation of the [Ableton version](/tutorials/alder-well/). Its explicit FM index, near-3:1 oscillator ratio, exponential curves, tanh saturation and reverb feedback are Csound choices. They approximate the source's synthesis behavior without claiming identical Operator tuning, envelope, filter, Tone, Soft Sine or room algorithms. The small filter resonance is omitted. Pitch bend is not mapped; the score controls pitch and touch directly.

## Note instrument

| Control | Value |
| --- | --- |
| Signal engine | Csound 6 syntax, 48000 Hz, 16-sample control blocks, stereo |
| Finished stage | giStage = 5 |
| Note inputs | p3 held seconds; p4 MIDI pitch; p5 velocity 0–1 |
| Carrier waveform / phase | Sine / 0 cycles |
| Carrier amplitude | −3 dB × −10 dB × (0.4 + 0.6 × velocity) |
| Attack gate | Linear 0 → 1 in 1 ms |
| Body decay | Exponential 1 → 0.0001 in 1.10 s |
| Body release | 350 ms to 0.000001 |
| Modulator waveform / phase | Sine / 0 cycles |
| Modulator ratio | 3.051 × carrier frequency |
| Modulation index | 8 × ampdb(−12) × (0.3 + 0.7 × velocity) |
| Peak frequency deviation | Modulator frequency × modulation index |
| Modulator decay | Exponential 1 → 0.0001 in 172 ms |
| Modulator release | 100 ms to 0.000001 |
| Lowpass | Butterworth, 12 dB/octave |
| Cutoff | 5330 × 2^(0.6 × (MIDI note − 60) / 12) Hz; limited to 30–18000 Hz |
| Pitch envelope / LFO | None |

## Shared effects

| Control | Value | Audible behavior |
| --- | --- | --- |
| Saturator input | DC removal | Removes bias before the nonlinear curve |
| Curve | tanh(input × 3 × ampdb(1.2)) / 3 | Smoothly rounds loud peaks |
| Saturator mix | 60% clean + 40% shaped | Keeps the fundamental clear |
| Saturator trim | −1 dB | Balances level after shaping |
| Room predelay | 8 ms | Separates attack and room |
| reverbsc feedback | 0.68 | Short diffuse tail |
| Feedback damping | 4500 Hz | Darkens high-frequency decay |
| Reverb delay modulation | 0.35 | Subtle tail movement |
| Room mix | 85% dry + 15% wet | Leaves the strike in front |
| Output trim | −2.77 dB | Balances the finished signal |
| Output DC removal | Both channels | Removes residual DC |
| Stereo width | Unchanged | Retains the room's stereo difference |

## Stage selector and shared buses

`giStage` is cumulative: 1 gives the sine body; 2 adds FM and lowpass; 3 adds saturation; 4 adds the room; 5 adds the output stage. Instrument 90 processes every active note together and must stay active through the tail. It clears `gaVoice` after each control block.

The full connected script is included at the [end of the build guide](BUILD_GUIDE.md#full-csound-script).

## Opcode references

[oscili](https://csound.com/docs/manual/oscili.html) provides the oscillators. [expsegr](https://csound.com/docs/manual/expsegr.html) provides positive exponential segments with note-off release. [reverbsc](https://csound.com/docs/manual/reverbsc.html) provides the stereo room; its feedback control is not a decay time in seconds.

[Starting settings](STARTING_STATE.md) · [Build guide](BUILD_GUIDE.md)

[Read on playgrid.cc](https://playgrid.cc/tutorials/alder-well/csound/settings/)
