# Build Detuned Room Pad in SuperCollider

A stock-unit SuperCollider interpretation of [the Ableton sound](/tutorials/detuned-room-pad/) and its [Csound version](/tutorials/detuned-room-pad/csound/). Each stage changes the source or its effect chain; oscillator, filter, modal and room algorithms differ across platforms.

[Starting settings](STARTING_STATE.md) · [Complete settings](ALL_PARAMETERS.md). The full runnable script ends this guide.

## Step 1 — Blend the slowly beating saws

Select `~soundStage = 1` and evaluate the full script at the end of this guide. Wait for the instrument-ready message before playing.

Set `~soundStage = 1` in the full script. Mix three saws at frequency ratios 1, 1.001 and 1.008 with gains −6, −10 and −6.7 dB. Use 885 ms attack, full sustain and 3 s release at −9 dB instrument gain. The explicit ratio offsets interpret Operator Fine values, which are not cents. Velocity does not alter this source.

| SuperCollider control | Value |
| --- | --- |
| Ratios | 1 / 1.001 / 1.008 |
| Levels | −6 / −10 / −6.7 dB |
| Amplitude | 885 ms attack; full sustain; 3 s release |
| Instrument | −9 dB |

<audio controls preload="none" aria-label="SuperCollider Detuned Room Pad after step 1"><source src="audio/steps/step-01.webm" type="audio/webm"></audio>

[Sound after step 1 — WebM/Opus](audio/steps/step-01.webm)

## Step 2 — Open a gentle tracked filter

Set `~soundStage = 2` in the full script. Use a 2800 Hz ladder lowpass with 0.01 resonance and full pitch tracking. Its contour rises in 92 ms, decays over 4.3 s to 0.72 and releases over 3 s. A chosen 0.9-octave depth interprets the source 15% amount. The filter opens before the slower amplitude peak, then settles into a softer sustained spectrum.

| SuperCollider control | Value |
| --- | --- |
| Cutoff / resonance | 2800 Hz base / 0.01 |
| Contour | 92 ms / 4.3 s / 0.72 / 3 s |
| Envelope / tracking | 0.9 octaves / 1 octave per octave |

For `MoogFF`, multiply the stated source resonance amount by four to obtain its 0–4 gain argument (limited to 3.95). The complete script gives this gain expression beside each cutoff.

<audio controls preload="none" aria-label="SuperCollider Detuned Room Pad after step 2"><source src="audio/steps/step-02.webm" type="audio/webm"></audio>

[Sound after step 2 — WebM/Opus](audio/steps/step-02.webm)

## Step 3 — Add moving stereo chorus

Set `~soundStage = 3` in the full script. Move two delay taps around 15 ms by ±9 ms at 0.6 Hz, with opposite phases and 52% wet mix. The wet inputs remain full-band. Scale side information by 1; tap feedback is 0. These explicit tap depths interpret the source Amount and ensemble movement rather than copy the internal algorithm. Sustained notes reveal slow pitch interference.

| SuperCollider control | Value |
| --- | --- |
| Tap center / excursion | 15 / ±9 ms |
| Rate / wet | 0.6 Hz / 52% |
| Wet highpass | Off |
| Width / feedback | 1 / 0 |
| Warmth shaping | 0% smooth-drive interpretation |

<audio controls preload="none" aria-label="SuperCollider Detuned Room Pad after step 3"><source src="audio/steps/step-03.webm" type="audio/webm"></audio>

[Sound after step 3 — WebM/Opus](audio/steps/step-03.webm)

## Step 4 — Surround the tone with a damped room

Set `~soundStage = 4` and evaluate the full block. Feed the preceding signal into `FreeVerb2`, using its fully wet output and the dry/wet routing shown in the script. The room continues after individual note envelopes release. Predelay separates the initial articulation from the diffuse tail; the external wet mix controls how far that tail moves forward.

The SuperCollider room value is 0.782951 and damping is 0.71875. These dimensionless settings are choices for this algorithm, rather than equivalent values for Ableton decay or Csound feedback and damping. More damping darkens the circulating highs. Any input filters and mid/side width changes in this stage retain their own explicit settings in the full script.

| SuperCollider room control | Value |
| --- | --- |
| FreeVerb2 internal mix | 1, wet output only |
| Room | 0.782951 |
| Damping | 0.71875 |
| Predelay | 8 ms |
| External room wet | 50% |

| SuperCollider control | Value |
| --- | --- |
| Room side multiplier | 1 |
| Room input cuts | Off |

<audio controls preload="none" aria-label="SuperCollider Detuned Room Pad after step 4"><source src="audio/steps/step-04.webm" type="audio/webm"></audio>

[Sound after step 4 — WebM/Opus](audio/steps/step-04.webm)

## Downloads and settings

[Finished sound — WebM/Opus](audio/Detuned-Room-Pad.webm) · [Complete settings](ALL_PARAMETERS.md) · [Ableton version](/tutorials/detuned-room-pad/) · [Csound version](/tutorials/detuned-room-pad/csound/)

## Full SuperCollider script

The complete Detuned Room Pad instrument uses stock SuperCollider units. Set `~soundStage` from 1 to 4 and evaluate the entire block again to select a cumulative stage. Wait for the ready message; `~soundNote.(60, 0.8, 1)` plays MIDI 60 at velocity 0.8 with a one-second held duration. Held duration controls when release begins, while each source's decay and modulation continue independently. `~soundStop.()` frees the active instrument and its effects. This block replaces the previously installed PlayGrid instrument in the same interpreter.

```supercollider
(
~soundStage = 4;
~soundOutputScale = 1.162154;
~soundRelease = 3;
~soundNames = (motion: \pgDetunedRoomPadMotion, voice: \pgDetunedRoomPadVoice, effects: \pgDetunedRoomPadEffects);

~soundDefs = [
    SynthDef(\pgDetunedRoomPadMotion, { |out=0| Out.kr(out, DC.kr(0)) }),
    SynthDef(\pgDetunedRoomPadVoice, { |out=0, midi=60, velocity=0.8, gate=1, startMidi=60|
        var stage = ~soundStage;
    var aA = 0, aB = 0, aC = 0, aL = 0, aR = 0, aSource = 0, iHz = 0, iVelocity = 0;
    var kAmp = 0, kCut = 0, kFilter = 0;
    iHz = (midi).midicps;
    iVelocity = (velocity).clip(0, 1);
    aA = (Saw.ar((iHz * 1)) * ((0 - 6)).dbamp);
    aB = (Saw.ar((iHz * 1.001)) * ((0 - 10)).dbamp);
    aC = (Saw.ar((iHz * 1.008)) * ((0 - 6.7)).dbamp);
    aSource = ((aA + aB) + aC);
    if((stage >= 2)) {
    kFilter = EnvGen.kr(Env([0, 1, 0.72, 0], [0.092, 4.3, 3], \lin, releaseNode: 2), gate);
    kCut = ((2800 * (2 ** ((0.9 * kFilter) + ((midi - 60) / 12))))).clip(30, 18000);
    aSource = MoogFF.ar(aSource, (kCut).clip(20, 18000), (0.01 * 4).clip(0, 3.95));
    };
    kAmp = EnvGen.kr(Env([0, 1, 1, 0], [0.885, 1.21, 3], \lin, releaseNode: 2), gate);
    aL = ((aSource * kAmp) * ((0 - 9)).dbamp);
    aR = aL;
    Out.ar(out, [aL, aR]);
        EnvGen.kr(Env.asr(0.0001, 1, 3), gate, doneAction: 2);
    }),
    SynthDef(\pgDetunedRoomPadEffects, { |in=0, out=0|
        var stage = ~soundStage;
        var outputScale = ~soundOutputScale;
        var input = In.ar(in, 2);
    var feedback = LocalIn.ar(2);
    var aChFbL = 0, aChFbR = 0, aChInL = 0, aChInR = 0, aChMid = 0, aChSide = 0, aChTimeL = 0, aChTimeR = 0;
    var aL = 0, aR = 0, aRoomInL = 0, aRoomInR = 0, aRoomL = 0, aRoomMid = 0, aRoomPreL = 0, aRoomPreR = 0;
    var aRoomR = 0, aRoomSide = 0, aTapL = 0, aTapR = 0, kCh = 0, room26 = 0;
    aL = input[0];
    aR = input[1];
    if((stage >= 3)) {
    aChFbL = feedback[0];
    aChFbR = feedback[1];
    aChInL = aL;
    aChInR = aR;
    kCh = (SinOsc.kr(0.6, 0 * 2pi) * 1);
    aChTimeL = K2A.ar((15 + (9.0 * kCh)));
    aChTimeR = K2A.ar((15 - (9.0 * kCh)));
    aTapL = DelayC.ar((aChInL + (aChFbL * 0)), 80 / 1000, (aChTimeL / 1000).clip(0.00002, 80 / 1000));
    aTapR = DelayC.ar((aChInR + (aChFbR * 0)), 80 / 1000, (aChTimeR / 1000).clip(0.00002, 80 / 1000));
    aChFbL = aTapL;
    aChFbR = aTapR;
    aL = ((aL * 0.48) + (aTapL * 0.52));
    aR = ((aR * 0.48) + (aTapR * 0.52));
    aChMid = ((aL + aR) * 0.5);
    aChSide = (((aL - aR) * 0.5) * 1);
    aL = (aChMid + aChSide);
    aR = (aChMid - aChSide);
    };
    if((stage >= 4)) {
    aRoomInL = aL;
    aRoomPreL = DelayN.ar(aRoomInL, 0.008, 0.008);
    aRoomInR = aR;
    aRoomPreR = DelayN.ar(aRoomInR, 0.008, 0.008);
    room26 = FreeVerb2.ar(aRoomPreL, aRoomPreR, 1, 0.782951, 0.71875);
    aRoomL = room26[0];
    aRoomR = room26[1];
    aRoomMid = ((aRoomL + aRoomR) * 0.5);
    aRoomSide = (((aRoomL - aRoomR) * 0.5) * 1);
    aL = ((aL * 0.5) + ((aRoomMid + aRoomSide) * 0.5));
    aR = ((aR * 0.5) + ((aRoomMid - aRoomSide) * 0.5));
    };
    LocalOut.ar([aChFbL, aChFbR].collect { |channel| channel + DC.ar(0) });
    Out.ar(out, [((aL * 1) * outputScale), ((aR * 1) * outputScale)]);
    })
];
~soundStop = {
    if(~cirrusGroup.notNil) { ~cirrusGroup.free; ~cirrusGroup = nil };
    if(~cirrusAudio.notNil) { ~cirrusAudio.free; ~cirrusAudio = nil };
    if(~cirrusMotion.notNil) { ~cirrusMotion.free; ~cirrusMotion = nil };
    if(~pgGroup.notNil) { ~pgGroup.free; ~pgGroup = nil };
    if(~pgAudio.notNil) { ~pgAudio.free; ~pgAudio = nil };
    if(~pgMotion.notNil) { ~pgMotion.free; ~pgMotion = nil };
};
~soundInstall = {
    s.waitForBoot {
        ~soundStop.();
        ~soundDefs.do { |definition| definition.add };
        s.sync;
        ~pgAudio = Bus.audio(s, 2);
        ~pgMotion = Bus.control(s, 1);
        ~pgGroup = Group.head(s);
        ~pgLastMidi = 60;
        Synth.head(~pgGroup, ~soundNames.motion, [\out, ~pgMotion]);
        ~pgVoices = Group.tail(~pgGroup);
        Synth.tail(~pgGroup, ~soundNames.effects, [\in, ~pgAudio]);
        "Detuned Room Pad ready".postln;
    };
};
~soundNote = { |midi=60, velocity=0.8, hold=1|
    var note = Synth.head(~pgVoices, ~soundNames.voice, [
        \out, ~pgAudio, \midi, midi, \velocity, velocity.clip(0, 1),
        \startMidi, ~pgLastMidi
    ]);
    ~pgLastMidi = midi;
    SystemClock.sched(hold, { note.set(\gate, 0); nil });
    note;
};
if(~soundOffline != true) { ~soundInstall.() };
)
```

[Read on playgrid.cc](https://playgrid.cc/tutorials/detuned-room-pad/supercollider/)
