# Ember Thump — SuperCollider starting settings

## First-stage source

Select `~soundStage = 1` and evaluate the full script at the end of this guide. Wait for the instrument-ready message before playing.

Set `~soundStage = 1` in the full script. Use a retriggered sine at -3.0 dB, transposed -12 semitones. Attack is 0.0005 seconds, exponential decay 0.46 seconds, sustain 0 and release 0.15 seconds. Positive exponential floors stand in for silence. The contour starts again for each played note; it differs from Operator's Trigger envelope behavior on very short held notes.

| SuperCollider control | Value |
| --- | --- |
| Carrier | Sine, phase 0 |
| Amplitude A/D/S/R | 0.0005 / 0.46 / 0 / 0.15 |
| Instrument gain | -10 dB |
| Transpose | -12 st |

## Later sound shaping

- Stage 2: Build the characteristic spectrum.
- Stage 3: Round the signal with saturation.
- Stage 4: Set the final width and gain.

The fixed output multiplier `~soundOutputScale` is 0.8708327. The connected [full script](/tutorials/ember-thump/supercollider/#full-supercollider-script) supplies all declarations and shared effects. [Complete settings](ALL_PARAMETERS.md) describe the SuperCollider-specific algorithms and their differences.

[Read on playgrid.cc](https://playgrid.cc/tutorials/ember-thump/supercollider/starting-state/)
