# Pollen Gleam — Complete device settings

Pollen Gleam is a string sound made with Wavetable, Chorus-Ensemble, Reverb and Utility.

Signal flow: **Wavetable → Chorus-Ensemble → Reverb → Utility**.

Controls retain the labels and units shown by the devices. A control in a switched-off section remains inactive until that section is enabled.

## Wavetable

| Control | Value |
| --- | --- |
| Device On | On |
| Osc 1 On | On |
| Osc 1 Transp | 0 st |
| Osc 1 Detune | 0 ct |
| Osc 1 Pos | 66 % |
| Osc 1 Effect 1 | 0.0 % |
| Osc 1 Effect 2 | 0.0 % |
| Osc 1 Pan | C |
| Osc 1 Gain | -13 dB |
| Osc 2 On | On |
| Osc 2 Transp | 0 st |
| Osc 2 Detune | 7 ct |
| Osc 2 Pos | 65 % |
| Osc 2 Effect 1 | 0.0 % |
| Osc 2 Effect 2 | 0.0 % |
| Osc 2 Pan | C |
| Osc 2 Gain | -16 dB |
| Sub On | Off |
| Sub Tone | 0.0 % |
| Sub Gain | -6.0 dB |
| Sub Transpose | -1 |
| Flt 1 On | On |
| Flt 1 Type | Lowpass |
| Flt 1 LP/HP | Clean |
| Flt 1 BP/NO/MO | Clean |
| Flt 1 Slope | 12 |
| Flt 1 Freq | 2.50 kHz |
| Flt 1 Res | 8.0 % |
| Flt 1 Drive | 0.00 dB |
| Flt 1 Morph | 0 lp/bp |
| Flt 2 On | On |
| Flt 2 Type | Highpass |
| Flt 2 LP/HP | Clean |
| Flt 2 BP/NO/MO | Clean |
| Flt 2 Slope | 12 |
| Flt 2 Freq | 110 Hz |
| Flt 2 Res | 0.0 % |
| Flt 2 Drive | 0.00 dB |
| Flt 2 Morph | 0 lp/bp |
| Amp Attack | 272 ms |
| Amp Decay | 1.67 s |
| Amp Release | 2.20 s |
| Amp A Slope | 0.0 % |
| Amp D Slope | 50 % |
| Amp R Slope | 50 % |
| Amp Sustain | -1.0 dB |
| Amp Loop Mode | None |
| Env 2 Attack | 1.50 s |
| Env 2 Decay | 2.80 s |
| Env 2 Release | 2.00 s |
| Env 2 A Slope | 0.0 % |
| Env 2 D Slope | 50 % |
| Env 2 R Slope | 50 % |
| Env 2 Initial | 0.0 % |
| Env 2 Peak | 100 % |
| Env 2 Sustain | 85 % |
| Env 2 Final | 0.0 % |
| Env 2 Loop Mode | None |
| Env 3 Attack | 1.00 ms |
| Env 3 Decay | 600 ms |
| Env 3 Release | 600 ms |
| Env 3 A Slope | 0.0 % |
| Env 3 D Slope | 50 % |
| Env 3 R Slope | 50 % |
| Env 3 Initial | 0.0 % |
| Env 3 Peak | 100 % |
| Env 3 Sustain | 50 % |
| Env 3 Final | 0.0 % |
| Env 3 Loop Mode | None |
| LFO 1 Retrigger | Off |
| LFO 1 Shape | Sine |
| LFO 1 Amount | 100 % |
| LFO 1 Shaping | 0.0 % |
| LFO 1 Phase Offset | 0.0° |
| LFO 1 Sync | Free |
| LFO 1 Rate | 0.12 Hz |
| LFO 1 S. Rate | 1/8 |
| LFO 1 Attack Time | 0.00 ms |
| LFO 2 Retrigger | On |
| LFO 2 Shape | Sine |
| LFO 2 Amount | 100 % |
| LFO 2 Shaping | 0.0 % |
| LFO 2 Phase Offset | 0.0° |
| LFO 2 Sync | Free |
| LFO 2 Rate | 1.00 Hz |
| LFO 2 S. Rate | 1/8 |
| LFO 2 Attack Time | 0.00 ms |
| Time | 0.0 % |
| Global Mod Amount | 100 % |
| Unison Amount | 15 % |
| Transpose | 0 st |
| Glide | 0.00 ms |
| Volume | -8.0 dB |

### Voicing and modulation

Choose the waveform and voicing controls below. In the Matrix and MIDI tabs, set the listed routes; leave unlisted routes at zero. The modulation amounts are the values shown in the matrix. Poly voices apply in Poly mode.

| Control | Value |
| --- | --- |
| Oscillator 1 category | Basics |
| Oscillator 1 wavetable | Basic Shapes |
| Oscillator 1 effect mode | None |
| Oscillator 2 category | Basics |
| Oscillator 2 wavetable | Pulse PW |
| Oscillator 2 effect mode | None |
| Voicing | Poly |
| Poly voices | 8 |
| Unison mode | Classic |
| Unison voices | 5 |
| Filter routing | Serial |
| Velocity → Volume | 45 |
| Pitch Bend → Transpose | 2 st |
| Env 2 → Flt 1 Freq | 10 |
| Note → Flt 1 Freq | 15 |
| Mod Wheel → Flt 1 Freq | 12 |
| LFO 1 → Osc 2 Pos | 6 |

## Chorus-Ensemble

| Control | Value |
| --- | --- |
| Device On | On |
| Mode | Ensemble |
| Shape | 0.0 % |
| Rate | 0.36 Hz |
| Amount | 25 % |
| Feedback | 0.0 % |
| FB Invert | Off |
| Offset | 0.0° |
| Delay Time | 20 ms |
| Delay Taps | 2 |
| HP On | On |
| HP Freq | 220 Hz |
| Width | 110 % |
| Warmth | 15 % |
| Output | 0.0 dB |
| Dry/Wet | 30 % |

## Reverb

| Control | Value |
| --- | --- |
| Device On | On |
| Predelay | 22.0 ms |
| In Lo Cut On | Off |
| In Hi Cut On | Off |
| Input Freq | 830 Hz |
| Input Width | 5.85 |
| ER Spin On | On |
| ER Spin Rate | 0.30 Hz |
| ER Spin Amount | 17.50 |
| ER Shape | 0.50 |
| Diff. Hi On | On |
| Diff. Hi Type | Shelf |
| Diff. Hi Freq | 3.50 kHz |
| HiShelf Gain | 0.60 |
| Diff. Lo On | Off |
| Diff. Lo Freq | 90.0 Hz |
| LowShelf Gain | 0.75 |
| Chorus On | On |
| Chorus Rate | 0.02 Hz |
| Chorus Amount | 0.02 |
| Decay Time | 2.94 s |
| Diffusion | 60 % |
| Scale | 40 % |
| Freeze On | Off |
| Flat On | On |
| Cut On | On |
| Room Size | 85.00 |
| Size Smoothing | Fast |
| Stereo Image | 100.00 |
| Density | High |
| Reflect Level | 0.0 dB |
| Diffuse Level | 0.0 dB |
| Dry/Wet | 24 % |

## Utility

| Control | Value |
| --- | --- |
| Device On | On |
| Left Inv | Off |
| Right Inv | Off |
| Channel Mode | Stereo |
| Stereo Width | 100 % |
| Mono | Off |
| Bass Mono | On |
| Bass Freq | 180 Hz |
| Balance | C |
| Output | 3.73 dB |
| Mute | Off |
| DC Filter | On |

[Build guide](BUILD_GUIDE.md) · [Read these settings on playgrid.cc](https://playgrid.cc/tutorials/pollen-gleam/settings/)