# Build Reedlight Organ in Csound

[SuperCollider version](/tutorials/reedlight-organ/supercollider/): the same sound interpreted with stock SuperCollider synthesis units.

Reedlight Organ in Csound follows the sound-shaping ideas of the [Ableton Operator version](/tutorials/reedlight-organ/), using the explicit oscillators, contours and effects below.

[Starting settings](STARTING_STATE.md) · [Complete settings](ALL_PARAMETERS.md). The complete script follows the final step and related sounds.

## Step 1 — Shape the sine body

Set `giStage init 1` in the full script. Use a retriggered sine at -8.0 dB, transposed 0 semitones. Attack is 0.012 seconds, exponential decay 0.8 seconds, sustain 1 and release 0.17 seconds. Positive exponential floors stand in for silence. The contour starts again for each score note; it differs from Operator's Trigger envelope behavior on very short held notes.

| Csound control | Value |
| --- | --- |
| Carrier | Sine, phase 0 |
| Amplitude A/D/S/R | 0.012 / 0.8 / 1 / 0.17 |
| Instrument gain | -8.0 dB |
| Transpose | 0 st |

<audio controls preload="none" aria-label="Csound Reedlight Organ after step 1"><source src="audio/steps/step-01.webm" type="audio/webm"></audio>

[Sound after step 1 — WebM/Opus](audio/steps/step-01.webm)

## Step 2 — Build the characteristic spectrum

Set `giStage init 2` in the full script. Add parallel sines at ratios 2, 3 and 4 with levels −13, −19 and −24 dB. They use the same amplitude contour. A tracked 5600 Hz lowpass softens the upper edge without turning the additive layers into FM. The exact source circuit and low-level envelope behavior are represented by the explicit code in the full script.

| Csound control | Value |
| --- | --- |
| Added source / motion | Sine ratios 2/3/4: −13/−19/−24 dB |
| Filter | 5.60 kHz |
| Filter type | Lowpass |

<audio controls preload="none" aria-label="Csound Reedlight Organ after step 2"><source src="audio/steps/step-02.webm" type="audio/webm"></audio>

[Sound after step 2 — WebM/Opus](audio/steps/step-02.webm)

## Step 3 — Add moving stereo chorus

Set `giStage init 3` in the full script. Move two delay taps around 12 ms by ±3.6 ms at 0.65 Hz, with opposite phases and 22% wet mix. Highpass only the wet inputs at 180 Hz to leave the direct low body clear. Scale side information by 1; tap feedback is 0. These explicit tap depths interpret the source Amount and ensemble movement rather than copy the internal algorithm. Sustained notes reveal slow pitch interference.

| Csound control | Value |
| --- | --- |
| Tap center / excursion | 12 / ±3.6 ms |
| Rate / wet | 0.65 Hz / 22% |
| Wet highpass | 180 Hz |
| Width / feedback | 1 / 0 |
| Warmth shaping | 0% smooth-drive interpretation |

<audio controls preload="none" aria-label="Csound Reedlight Organ after step 3"><source src="audio/steps/step-03.webm" type="audio/webm"></audio>

[Sound after step 3 — WebM/Opus](audio/steps/step-03.webm)

## Step 4 — Surround the tone with a damped room

Set `giStage init 4` in the full script. Feed the preceding signal through 12 ms predelay into `reverbsc`, with feedback 0.6918, 4500 Hz damping and 18% wet mix. Predelay leaves the initial articulation in front; feedback prolongs the tail, while damping darkens repeated circulation. The source room decay setting is 1.9 seconds, but Csound feedback is not a decay-time control: this is an interpretation of that space, with different diffusion and modulation. 

| Csound control | Value |
| --- | --- |
| Source decay target | 1.9 s (not a measured Csound decay) |
| Predelay / feedback | 12 ms / 0.6918 |
| Damping / wet | 4500 Hz / 18% |
| Room side multiplier | 1 |
| Room input cuts | Off |

<audio controls preload="none" aria-label="Csound Reedlight Organ after step 4"><source src="audio/steps/step-04.webm" type="audio/webm"></audio>

[Sound after step 4 — WebM/Opus](audio/steps/step-04.webm)

## Step 5 — Set the final width and gain

Set `giStage init 5` in the full script. Use -7.37 dB gain after the effects. Scale the side signal by 1, preserving the center. Highpass only the side at 140 Hz to focus the lowest frequencies. Apply order-2048 DC removal, using a longer window to limit low-note loss. The fixed output-scale control at the end of instrument 90 remains a separate Csound gain setting. Clear the shared note buses only after processing them; effect memories continue carrying their own tails.

| Csound control | Value |
| --- | --- |
| Final gain | -7.37 dB |
| Width | 1 × side |
| Bass side cutoff | 140 Hz |
| DC removal | Order 2048 |

<audio controls preload="none" aria-label="Csound Reedlight Organ after step 5"><source src="audio/steps/step-05.webm" type="audio/webm"></audio>

[Sound after step 5 — WebM/Opus](audio/steps/step-05.webm)

## Downloads and settings

[Finished sound — WebM/Opus](audio/reedlight-organ.webm) · [Complete settings](ALL_PARAMETERS.md) · [Ableton version](/tutorials/reedlight-organ/)

## Full Csound script

This document contains the complete Reedlight Organ source, shared effects and example score. `giStage` selects the cumulative stages from 1 to 5; 5 is the finished sound.

```csound
<CsoundSynthesizer>
<CsOptions>
-odac -d
</CsOptions>
<CsInstruments>
sr = 48000
ksmps = 16
nchnls = 2
0dbfs = 1

giStage init 5
giOutputScale init 1.772815
giSine ftgen 0, 0, 16384, 10, 1
gaLeft init 0
gaRight init 0

instr 1
  iHz = cpsmidinn(p4)
  iVelocity = limit(p5, 0, 1)
  kPitch = 0
  kHz = iHz*pow(2,(0+kPitch)/12)
  aSource oscili ampdb(-8.0), kHz, giSine, 0
  aAmpGate linseg 0, 0.012, 1, 1, 1
  aAmpDecay expsegr 1, 0.012, 1, 0.8, 1.0, 0.17, 0.000001
  aAmp = aAmpGate*aAmpDecay
  aSource = aSource*aAmp
  if giStage >= 2 then
  aH2 oscili ampdb(-13), kHz*2, giSine, 0
  aSource = aSource+aH2*aAmp
  aH3 oscili ampdb(-19), kHz*3, giSine, 0
  aSource = aSource+aH3*aAmp
  aH4 oscili ampdb(-24), kHz*4, giSine, 0
  aSource = aSource+aH4*aAmp
  aSource butterlp aSource,limit(5600*pow(2,0.5*(p4-60)/12),30,18000)
  endif
  aL = aSource*ampdb(-8.0)*(0.65+0.35*iVelocity)
  aR = aL
  gaLeft = gaLeft+aL
  gaRight = gaRight+aR
endin
instr 90
  aL = gaLeft
  aR = gaRight
  if giStage >= 3 then
    aChFbL init 0
    aChFbR init 0
    aChInL butterhp aL, 180.0
    aChInR butterhp aR, 180.0
    kCh oscili 1, 0.65, giSine
    aChTimeL interp 12+3.6*kCh
    aChTimeR interp 12-3.6*kCh
    aTapL vdelay3 aChInL+aChFbL*0, aChTimeL, 80
    aTapR vdelay3 aChInR+aChFbR*0, aChTimeR, 80
    aChFbL = aTapL
    aChFbR = aTapR
    aL = aL*0.78+aTapL*0.22
    aR = aR*0.78+aTapR*0.22
    aChMid = (aL+aR)*0.5
    aChSide = (aL-aR)*0.5*1.0
    aL = aChMid+aChSide
    aR = aChMid-aChSide
  endif
  if giStage >= 4 then
    aRoomInL = aL
    aRoomPreL delay aRoomInL, 0.012
    aRoomInR = aR
    aRoomPreR delay aRoomInR, 0.012
    aRoomL, aRoomR reverbsc aRoomPreL, aRoomPreR, 0.6918, 4500.0, sr, 0.4
    aRoomMid = (aRoomL+aRoomR)*0.5
    aRoomSide = (aRoomL-aRoomR)*0.5*1
    aL = aL*0.8200000000000001+(aRoomMid+aRoomSide)*0.18
    aR = aR*0.8200000000000001+(aRoomMid-aRoomSide)*0.18
  endif
  if giStage >= 5 then
    aEndMid = (aL+aR)*0.5
    aEndSide = (aL-aR)*0.5*1.0
    aEndSide butterhp aEndSide, 140.0
    aL = (aEndMid+aEndSide)*ampdb(-7.37)
    aL dcblock2 aL, 2048
    aR = (aEndMid-aEndSide)*ampdb(-7.37)
    aR dcblock2 aR, 2048
  endif
  outs aL*giOutputScale, aR*giOutputScale
  clear gaLeft, gaRight
endin
</CsInstruments>
<CsScore>
; p3 held seconds, p4 MIDI pitch, p5 velocity
i 1 0 0.7 60 0.8
i 1 1.6 0.7 64 0.95
i 1 3.2 0.7 67 0.7
i 90 0 14.07
e
</CsScore>
</CsoundSynthesizer>
```

[Read on playgrid.cc](https://playgrid.cc/tutorials/reedlight-organ/csound/)
