# Build Sorrel Hollow in SuperCollider

A stock-unit SuperCollider interpretation of [the Ableton sound](/tutorials/sorrel-hollow/) and its [Csound version](/tutorials/sorrel-hollow/csound/). Each stage changes the source or its effect chain; oscillator, filter, modal and room algorithms differ across platforms.

[Starting settings](STARTING_STATE.md) · [Complete settings](ALL_PARAMETERS.md). The full runnable script ends this guide.

## Step 1 — Shape the drifting bass body

Select `~soundStage = 1` and evaluate the full script at the end of this guide. Wait for the instrument-ready message before playing.

Set `~soundStage = 1` in the full script. Use saw at -8.0 dB, with ±0.6 cents of slow note-local pitch drift. Set attack 0.0068 s, decay 1.29 s, sustain 0.7 and release 0.203 s. Keep the source centered. This replaces Drift's irregular oscillator instability with a small sine drift; glide and mono note-priority are not implemented.

| SuperCollider control | Value |
| --- | --- |
| Wave / gain | Saw / -8.0 dB |
| Amplitude A/D/S/R | 0.0068 / 1.29 / 0.7 / 0.203 |
| Instrument / velocity | -6.0 dB / 40 % |
| Drift | ±0.6 cents at 0.19 Hz |

<audio controls preload="none" aria-label="SuperCollider Sorrel Hollow after step 1"><source src="audio/steps/step-01.webm" type="audio/webm"></audio>

[Sound after step 1 — WebM/Opus](audio/steps/step-01.webm)

## Step 2 — Add the sub and lowpass movement

Set `~soundStage = 2` in the full script. Add an octave-down sine at -7.0 dB. Route both sources through a 244 Hz ladder lowpass with 0.25 resonance, followed by the 25 Hz highpass. The second envelope moves cutoff by 0.9 octaves; keyboard and velocity amounts add their own opening. The filter type and modulation scaling interpret the source rather than copy its Type II circuit.

| SuperCollider control | Value |
| --- | --- |
| Sub | Octave down, -7.0 dB |
| Cutoff / resonance | 244 Hz / 0.25 |
| Filter A/D/S/R | 0.002 / 0.45 / 0.2 / 0.2 |
| Envelope / key / velocity depth | 0.9 / 0.6 / 0.24 octaves |

For `MoogFF`, multiply the stated source resonance amount by four to obtain its 0–4 gain argument (limited to 3.95). The complete script gives this gain expression beside each cutoff.

<audio controls preload="none" aria-label="SuperCollider Sorrel Hollow after step 2"><source src="audio/steps/step-02.webm" type="audio/webm"></audio>

[Sound after step 2 — WebM/Opus](audio/steps/step-02.webm)

## Step 3 — Round the signal with saturation

Set `~soundStage = 3` in the full script. Use +2.3 dB drive with 70% shaped signal and -2 dB output trim. The smooth curve is `tanh(input × 3 × drive.dbamp) / 3`; the other portion stays clean. Louder peaks enter its curved region more strongly, adding harmonics and rounding the envelope. This interprets the source saturation curve rather than implementing its proprietary transfer function.

| SuperCollider control | Value |
| --- | --- |
| Drive / output | 2.3 / -2 dB |
| Shaped mix | 70% |
| Input DC removal | LeakDC, coefficient 0.995 |

<audio controls preload="none" aria-label="SuperCollider Sorrel Hollow after step 3"><source src="audio/steps/step-03.webm" type="audio/webm"></audio>

[Sound after step 3 — WebM/Opus](audio/steps/step-03.webm)

## Step 4 — Set the final width and gain

Set `~soundStage = 4` in the full script. Use 2.86 dB gain after the effects. Average the channels for identical mono outputs. Apply `LeakDC` DC removal with coefficient 0.995. The fixed `~soundOutputScale` gain follows the complete effect chain at every stage. The effects Synth reads the stereo bus after the note group, and continues through note releases.

| SuperCollider control | Value |
| --- | --- |
| Final gain | 2.86 dB |
| Width | Mono |
| Bass side cutoff | Off |
| DC removal | LeakDC, coefficient 0.995 |

<audio controls preload="none" aria-label="SuperCollider Sorrel Hollow after step 4"><source src="audio/steps/step-04.webm" type="audio/webm"></audio>

[Sound after step 4 — WebM/Opus](audio/steps/step-04.webm)

## Downloads and settings

[Finished sound — WebM/Opus](audio/sorrel-hollow.webm) · [Complete settings](ALL_PARAMETERS.md) · [Ableton version](/tutorials/sorrel-hollow/) · [Csound version](/tutorials/sorrel-hollow/csound/)

## Full SuperCollider script

The complete Sorrel Hollow instrument uses stock SuperCollider units. Set `~soundStage` from 1 to 4 and evaluate the entire block again to select a cumulative stage. Wait for the ready message; `~soundNote.(60, 0.8, 1)` plays MIDI 60 at velocity 0.8 with a one-second held duration. Held duration controls when release begins, while each source's decay and modulation continue independently. `~soundStop.()` frees the active instrument and its effects. This block replaces the previously installed PlayGrid instrument in the same interpreter.

```supercollider
(
~soundStage = 4;
~soundOutputScale = 1.267126;
~soundRelease = 0.203;
~soundNames = (motion: \pgSorrelHollowMotion, voice: \pgSorrelHollowVoice, effects: \pgSorrelHollowEffects);

~soundDefs = [
    SynthDef(\pgSorrelHollowMotion, { |out=0| Out.kr(out, DC.kr(0)) }),
    SynthDef(\pgSorrelHollowVoice, { |out=0, midi=60, velocity=0.8, gate=1, startMidi=60|
        var stage = ~soundStage;
    var aL = 0, aR = 0, aSource = 0, aSub = 0, iHz = 0, iVelocity = 0, kAmp = 0, kCut = 0;
    var kDrift = 0, kFilter = 0, kHz = 0;
    iHz = (midi).midicps;
    iVelocity = (velocity).clip(0, 1);
    kDrift = (SinOsc.kr(0.19, 0 * 2pi) * 0.6000000000000001);
    kHz = (iHz * (2 ** (kDrift / 1200)));
    aSource = (Saw.ar(kHz) * ((0 - 8.0)).dbamp);
    if((stage >= 2)) {
    aSub = (SinOsc.ar((kHz * 0.5), 0 * 2pi) * ((0 - 7.0)).dbamp);
    aSource = (aSource + aSub);
    kFilter = EnvGen.kr(Env([0, 1, 0.2, 0], [0.002, 0.45, 0.2], \lin, releaseNode: 2), gate);
    kCut = ((244.0 * (2 ** (((0.8999999999999999 * kFilter) + ((0.6 * (midi - 60)) / 12)) + (0.24 * iVelocity))))).clip(30, 18000);
    aSource = MoogFF.ar(aSource, (kCut).clip(20, 18000), (0.25 * 4).clip(0, 3.95));
    aSource = HPF.ar(aSource, (25.0).clip(20, 18000));
    };
    kAmp = EnvGen.kr(Env([0, 1, 0.7, 0], [0.0068, 1.29, 0.203], \lin, releaseNode: 2), gate);
    aL = (((aSource * kAmp) * ((0 - 6.0)).dbamp) * (0.6 + (0.4 * iVelocity)));
    aR = aL;
    Out.ar(out, [aL, aR]);
        EnvGen.kr(Env.asr(0.0001, 1, 0.203), gate, doneAction: 2);
    }),
    SynthDef(\pgSorrelHollowEffects, { |in=0, out=0|
        var stage = ~soundStage;
        var outputScale = ~soundOutputScale;
        var input = In.ar(in, 2);
    var aCleanL = 0, aCleanR = 0, aEndMid = 0, aEndSide = 0, aL = 0, aR = 0, aShapeL = 0, aShapeR = 0;
    aL = input[0];
    aR = input[1];
    if((stage >= 3)) {
    aCleanL = LeakDC.ar(aL, 0.995);
    aShapeL = ((((aCleanL * 3) * (2.3).dbamp)).tanh / 3);
    aL = (((aCleanL * 0.30000000000000004) + (aShapeL * 0.7)) * ((0 - 2.0)).dbamp);
    aCleanR = LeakDC.ar(aR, 0.995);
    aShapeR = ((((aCleanR * 3) * (2.3).dbamp)).tanh / 3);
    aR = (((aCleanR * 0.30000000000000004) + (aShapeR * 0.7)) * ((0 - 2.0)).dbamp);
    };
    if((stage >= 4)) {
    aEndMid = ((aL + aR) * 0.5);
    aEndSide = (((aL - aR) * 0.5) * 0);
    aL = ((aEndMid + aEndSide) * (2.86).dbamp);
    aL = LeakDC.ar(aL, 0.995);
    aR = ((aEndMid - aEndSide) * (2.86).dbamp);
    aR = LeakDC.ar(aR, 0.995);
    };
    Out.ar(out, [((aL * 1) * outputScale), ((aR * 1) * outputScale)]);
    })
];
~soundStop = {
    if(~cirrusGroup.notNil) { ~cirrusGroup.free; ~cirrusGroup = nil };
    if(~cirrusAudio.notNil) { ~cirrusAudio.free; ~cirrusAudio = nil };
    if(~cirrusMotion.notNil) { ~cirrusMotion.free; ~cirrusMotion = nil };
    if(~pgGroup.notNil) { ~pgGroup.free; ~pgGroup = nil };
    if(~pgAudio.notNil) { ~pgAudio.free; ~pgAudio = nil };
    if(~pgMotion.notNil) { ~pgMotion.free; ~pgMotion = nil };
};
~soundInstall = {
    s.waitForBoot {
        ~soundStop.();
        ~soundDefs.do { |definition| definition.add };
        s.sync;
        ~pgAudio = Bus.audio(s, 2);
        ~pgMotion = Bus.control(s, 1);
        ~pgGroup = Group.head(s);
        ~pgLastMidi = 60;
        Synth.head(~pgGroup, ~soundNames.motion, [\out, ~pgMotion]);
        ~pgVoices = Group.tail(~pgGroup);
        Synth.tail(~pgGroup, ~soundNames.effects, [\in, ~pgAudio]);
        "Sorrel Hollow ready".postln;
    };
};
~soundNote = { |midi=60, velocity=0.8, hold=1|
    var note = Synth.head(~pgVoices, ~soundNames.voice, [
        \out, ~pgAudio, \midi, midi, \velocity, velocity.clip(0, 1),
        \startMidi, ~pgLastMidi
    ]);
    ~pgLastMidi = midi;
    SystemClock.sched(hold, { note.set(\gate, 0); nil });
    note;
};
if(~soundOffline != true) { ~soundInstall.() };
)
```

[Read on playgrid.cc](https://playgrid.cc/tutorials/sorrel-hollow/supercollider/)
