Copper Circuit — complete Csound settings
Signal flow and interpretation #
Centered saw and pulse → smoothly driven ladder lowpass → amplitude → shared saturation → mono gain and DC removal.
The Ableton version supplies source levels, pulse width, envelope times and the main cutoff. Csound uses its own ladder-filter response, explicit octave depths and a velocity^2.5 curve. The filter and saturator drive curves interpret Sym1 and Analog Clip rather than implement those algorithms. The LFO restarts per note instead of remaining free-running. Aftertouch and mono note-priority behavior are not mapped; no glide is added.
Instrument and effect controls #
| Control | Csound value |
|---|---|
| Initial source | Saw, −6 dB, MIDI pitch from p4, no unison or glide |
| Amplitude gate | Linear 5 ms to full level |
| Amplitude decay / sustain / release | Exponential 480 ms / 0.65 / 130 ms to 0.000001 |
| Amplifier / instrument gain | −6 dB / −6 dB |
| Touch curve | velocity^2.5 |
| Pulse source from stage 2 | Same pitch; width 0.38; −12 dB |
| Filter envelope | 5 ms gate; exponential 210 ms decay to 0.08; 130 ms release |
| Filter motion | 1.7 Hz sine; ±0.12 octaves; note-retriggered |
| Cutoff | 270 × 2^(3.20 × contour + 0.50 × (MIDI note − 60) / 12 + 0.12 × LFO) Hz; limited to 30–18000 Hz |
| Filter drive / resonance | tanh(source × 1.6) / 1.6; moogladder resonance 0.52 |
| Saturator from stage 3 | DC removal; tanh(input × 3 × ampdb(4)) / 3; 70% wet; −3 dB trim |
| Final stage 4 | Mono average; +3.65 dB; DC removal; identical left/right outputs |
Opcode references #
moogladder supplies the resonant ladder lowpass. vco2 supplies saw and pulse waveforms. The shared output is centered throughout; the last stage explicitly preserves identical left and right samples.
Full script and stage selector #
The full script contains options, both instrument definitions and an example score. Instrument 1 uses p3 for held seconds, p4 for MIDI pitch and p5 for velocity from 0 to 1. Instrument 90 reads the shared note buses and clears them after processing each control block. Keep it active while notes or effect tails sound. The stage selector is cumulative.
Starting settings · Build guide
DC-blocking window #
DC removal uses dcblock2 with order 2048. This longer window limits low-note attenuation compared with its default order of 128, while adding processing delay. The same filtered signal feeds both the clean and shaped saturation paths, keeping those paths aligned.