Step 01 / 4
Excite the marimba-like mode bank #
Set giStage init 1 in the full script. Use a 2 ms mallet pulse with 15% contact noise, lowpassed at 5000 Hz. Feed ratios 1, 4, 10 and 19.9 with progressively shorter decays. The non-harmonic spacing and fast upper-mode decay give a hollow, wooden strike. This four-mode bank interprets Collision's Marimba model; it does not implement the original material or listening-position solver.
| Csound control | Value |
|---|---|
| Ratios / weights | 1/4/10/19.9; weights 1/0.35/0.12/0.04 |
| T60 per mode | 1.5/0.8/0.4/0.2 s |
| Mallet / resonator / instrument | −12 / −6 / −9 dB |
| Modal scale | 0.04 |
| Touch | 0.4 + 0.6 × velocity |
Sound after step 1 — WebM/Opus
Next: Add the quieter upper beam →Step 02 / 4
Add the quieter upper beam #
Set giStage init 2 in the full script. Mix a second set of modes at ratios 2, 5.52 and 10.8, with 450 ms decay and −24 dB gain. The beam adds a short higher edge without replacing the main struck body. The two banks receive the same excitation in parallel, matching the source's 1 + 2 signal-flow idea. Their explicit modal ratios interpret the beam's tuning and inharmonicity.
| Csound control | Value |
|---|---|
| Beam ratios / weights | 2/5.52/10.8; 1/0.35/0.12 |
| Beam T60 / gain | 450 ms / −24 dB |
| Maximum modal frequency | 11000 Hz |
| Natural tail lifetime | 4 s beyond held duration |
Sound after step 2 — WebM/Opus
Next: Surround the tone with a damped room →Step 03 / 4
Surround the tone with a damped room #
Set giStage init 3 in the full script. Feed the preceding signal through 12 ms predelay into reverbsc, with feedback 0.6456, 4500 Hz damping and 18% wet mix. Predelay leaves the initial articulation in front; feedback prolongs the tail, while damping darkens repeated circulation. The source room decay setting is 1.6 seconds, but Csound feedback is not a decay-time control: this is an interpretation of that space, with different diffusion and modulation.
| Csound control | Value |
|---|---|
| Source decay target | 1.6 s (not a measured Csound decay) |
| Predelay / feedback | 12 ms / 0.6456 |
| Damping / wet | 4500 Hz / 18% |
| Room side multiplier | 1 |
| Room input cuts | Off |
Sound after step 3 — WebM/Opus
Next: Set the final width and gain →Step 04 / 4
Set the final width and gain #
Set giStage init 4 in the full script. Use -4.51 dB gain after the effects. Scale the side signal by 1, preserving the center. Highpass only the side at 160 Hz to focus the lowest frequencies. Apply order-2048 DC removal, using a longer window to limit low-note loss. The fixed output-scale control at the end of instrument 90 remains a separate Csound gain setting. Clear the shared note buses only after processing them; effect memories continue carrying their own tails.
| Csound control | Value |
|---|---|
| Final gain | -4.51 dB |
| Width | 1 × side |
| Bass side cutoff | 160 Hz |
| DC removal | Order 2048 |
Sound after step 4 — WebM/Opus
Audio & settings ↓