Slow Harmonic Pad complete settings

Back to the build

Use Operator followed by Chorus-Ensemble. All four oscillators are On and mix directly into the output.

Instrument global settings #

Operator has ten voices, global Retrig Off, interpolation and antialias On. The global matrix has velocity, aftertouch and mod-wheel connections Off, Key → Time at 0%, and Pitch Bend → Pitch at +2 st.

Oscillator controls outside the parameter tables #

For each active oscillator, select User waveform, 64 harmonics, Repeat Off, and turn Normalize Off in the harmonic editor’s context menu. Start with every partial cleared. Click Oscillator in the central display to draw the harmonic bars; click Envelope to adjust its shape. Each bar is one partial: bar 1 is the fundamental, bar 2 is twice its frequency, and so on. Use the partial-level readout while drawing; the values below are in dB relative to a full-height bar, not oscillator output levels.

Set Fixed Off, frequency quantization On, oscillator retrigger Off, Phase 0%, Feedback 0%, frequency/velocity modulation 0, and level/key scaling 0%. Leave oscillator pitch-envelope and LFO destination switches On; the global pitch envelope remains Off, and the LFO’s pitch amount will be zero.

Use envelope Initial and End −∞ dB, Peak and Sustain 0 dB, Decay 500 ms, Loop None, and time/release velocity scaling 0%. Set the amplitude envelope slopes to Attack 0%, Decay 100%, Release 0%: the attack and release segments should be straight. Peak and sustain are equal, so the decay segment stays flat.

Operator parameters #

Chorus-Ensemble parameters #

Shape and Offset apply in Vibrato mode and are inactive in this Chorus-mode sound. See the Chorus-Ensemble controls.

User waveform partials #

Partial levels in dB. All unlisted bars are Off. Set 64 harmonics, Repeat Off and Normalize Off for every oscillator. B and C use identical bars.