Step 01 / 4
Build the struck three-register body #
Set giStage init 1 in the full script. Use a pulse one octave above the note at −7 cents/−6 dB, a triangle two octaves above at −15 dB, and a quiet pulse at the played pitch at −27 dB. These fixed shapes interpret Basic Shapes positions and the colored sub rather than scan the original tables. The amplitude rises in 1 ms, decays over 1.4 s to −42 dB and releases over 250 ms.
| Csound control | Value |
|---|---|
| Main source | Pulse, octave up, −7 cents, −6 dB |
| Upper / low layer | Triangle +24 st at −15 dB / pulse at −27 dB |
| Amplitude | 1 ms / 1.4 s / −42 dB / 250 ms |
| Instrument / touch | −3 dB / 50% |
Sound after step 1 — WebM/Opus
Next: Close the strike filter quickly →Step 02 / 4
Close the strike filter quickly #
Set giStage init 2 in the full script. Apply a 1100 Hz ladder lowpass with +3 dB input drive and 0.062 resonance. Track pitch fully and open cutoff by 0.5 octaves under a 1 ms / 250 ms / zero / 100 ms contour. The fast spectral fall is independent of the longer amplitude decay.
| Csound control | Value |
|---|---|
| Cutoff / resonance | 1100 Hz base / 0.062 |
| Envelope / key tracking | 0.5 octaves / full |
| Filter contour | 1 ms / 250 ms / zero / 100 ms |
Sound after step 2 — WebM/Opus
Next: Round the signal with saturation →Step 03 / 4
Round the signal with saturation #
Set giStage init 3 in the full script. Use +22 dB drive with 50% shaped signal and -21 dB output trim. The smooth curve is tanh(input × 3 × ampdb(drive)) / 3; the other portion stays clean. Louder peaks enter its curved region more strongly, adding harmonics and rounding the envelope. This interprets the source saturation curve rather than implementing its proprietary transfer function. A final tanh stage also interprets Soft Clip on the output.
| Csound control | Value |
|---|---|
| Drive / output | 22 / -21 dB |
| Shaped mix | 50% |
| Input DC removal | Off |
| Post clip | tanh |
Sound after step 3 — WebM/Opus
Next: Surround the tone with a damped room →Step 04 / 4
Surround the tone with a damped room #
Set giStage init 4 in the full script. Feed the preceding signal through 8 ms predelay into reverbsc, with feedback 0.9209, 3000 Hz damping and 22% wet mix. Predelay leaves the initial articulation in front; feedback prolongs the tail, while damping darkens repeated circulation. The source room decay setting is 8.5 seconds, but Csound feedback is not a decay-time control: this is an interpretation of that space, with different diffusion and modulation.
| Csound control | Value |
|---|---|
| Source decay target | 8.5 s (not a measured Csound decay) |
| Predelay / feedback | 8 ms / 0.9209 |
| Damping / wet | 3000 Hz / 22% |
| Room side multiplier | 0.8 |
| Room input cuts | Off |
Sound after step 4 — WebM/Opus
Audio & settings ↓